HKSkook

Thanks man I went with the same blue ones cant wait to get them!!

rvastang

This thread was very helpful. I ended up doing this only with white LEDs. Looks great. I didn't use a screwdriver to get the housing off though. I just pulled. I was afraid the screwdriver might leave a mark.

IvanRad

http://www.ebay.com/itm/300650222270...84.m1438.l2649

will this work

just want to see how it ends up.

Paul_VS

They look too long, plus they're from China so if they don't you'll spend more to send them back than they cost.

IvanRad

http://pages.ebay.com/motors/link/?n...d=380527071981
better with 30 day return

Paul_VS

Still no.

Those are plank bulbs that are oriented to face straight out. Plank bulbs are fine, but you want the light to point down since the bulbs plug into your car at a 90degree angle to the dome light lens.

Like these:

http://www.vleds.com/bulb-type/minia...58-1-pair.html

Paul_VS

These are a good style bulb also:

http://www.ebay.com/itm/290850853186...84.m1423.l2649

Diode Dynamics

We have a big selection of these bulbs for the mustang, I have them in my 2007 GT.

Several colors available too



Here is a link to our Mustang replacement lighting: http://www.diodedynamics.com/store/l...1/mustang.html

Sure, you can find them cheaper on eBay, that's no secret. But the common eBay bulb has a much higher failure rate and doesn't come with our fantastic customer service. Plus, if you ever need help you can always PM me!

Thanks,
Nick C.

jakqbak04

Thanks for the advice it was exactly how you said, I was lucky enough the led's I bought were small enough that i didn't have to pop the front lens cover off.





I attached some before and after pics, and the type of led I placed in the car.

icepik1234

Just did this tonight. I was going to post some pictures but mine are blue and people already have posted those. First off I got mine from the diode dynamics link posted above. They seemed to have the easiest to figure out website of the ones linked so far. They shipped fast and had good packaging. You could probably find them cheaper somewhere else but they were convenient and ill probably order from them again(trunk and license plate are next). I had some tips I wanted to share for people that struggle with this as it too a while to figure it out. First the lenses do pop off very easily with a thin flathead. You have almost no issues with breaking them. Problem is as far as I can see its impossible to get the bulbs out without pulling the whole housing down. The clips are a pita to get undone. The sockets for the lights are in pretty tight so I had to use pliers. Grab them by the smaller sides and twist to one side and the clips holding them in should pop out. Make sure you test the lights out before you put it all back together as you could have them in backwards.