Shaker Scoop Modification
#11
Nice care too BTW!
#13
I like the trimmed look. Think i'm gonna go that route as well. Anyone have a link for the weatherstrip trim?
Here's a couple of pics of my setup. For the shaker duct to C&L box, I modified a section of the stock air duct. A future project will be an aluminum air box to hold the filter. I hate that plastic one.
Here's a couple of pics of my setup. For the shaker duct to C&L box, I modified a section of the stock air duct. A future project will be an aluminum air box to hold the filter. I hate that plastic one.
#14
I had bought it @ Autozone 4 yrs ago, it is a door/trunk edge weatherstrip that has a wire 'U' channel below the top weatherstrip. It just slides onto the trimmed edge of the Shaker. I cannot find the product anymore on the Autozone website. Have attached a pic that shows a similar product; found this on Amazon.com
Last edited by aircare84; 03-17-2011 at 08:08 PM.
#15
Scott
#16
Sorry for abandoning my post for a bit....went on vacation. Thanks aircare for the pics and info u emailed me...now i just gotta find the cash to buy a shaker. I am getting my car worked on next month. I am having a body shop go over the car again and fill all the nicks and scratches then "colorsand" and polish the whole thing and have the stripes redone.
#19
Thanks!
As for painting, I haven't done searched any threads yet. Are there things I need to know about before painting the throttle body or cam covers? I know removal threads are in here. Any painting issues? Or is it basically clean, prime, & paint?
As for painting, I haven't done searched any threads yet. Are there things I need to know about before painting the throttle body or cam covers? I know removal threads are in here. Any painting issues? Or is it basically clean, prime, & paint?
Thread
Thread Starter
Forum
Replies
Last Post
JoshyGT
S550 2015-2023 Mustang
16
09-19-2017 08:52 PM