You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
Why did you chose to disconnet the O2 sensors instead of just unscrewing them from the mid pipe, installing the new mid pipe and then screwing back in the O2 sensors?
Was it because it is hard to get a wrench to them while still connected to the mid pipe?
Just as bboren described, I found it easier to transfer the O2 sensors off the car rather than attempt to strugle a wrench up there (and also wanted to avoid any excessivewire twisting). Not to mention, applying the anti-sieze.
Quote:
ORIGINAL: Stoenr
I thought you did this along time ago Bill? Just now a how to? I swear I read this before?
Hey Stoenr, yup, you read this a while back (in TMS). I'm rewritting a few of my How-To's here in MF for all to enjoy![sm=smiley20.gif]
Quote:
ORIGINAL: jettaflavor
Dang - good job. Cops say anything about the noise?
Well, I rolled up on a couple Sheriff's (nervous as heck!), but I layed off the gas and just cruised by them. If I was on the 'Go Pedal', I'm sure they'll have plenty tosay!! [sm=smiley36.gif]
Well, I rolled up on a couple Sheriff's (nervous as heck!), but I layed off the gas and just cruised by them. If I was on the 'Go Pedal', I'm sure they'll have plenty tosay!! [sm=smiley36.gif]
haha, ive gone by plenty of cops and had them right behind me. not one has pulled me over yet. as long as im going the speed limit i just let off, or if im at a stop just dont gas it too much.
How long did this project take, including battery removal and replacement? Also did you change the over axel pipe or leave the stock over pipes in place?
How long did this project take, including battery removal and replacement? Also did you change the over axel pipe or leave the stock over pipes in place?
Well after doing a couple, I can swap it out in an hour. First timers can expect a couple hour job.
I still have the stock mid pipes. Besides that little pinch right over the axle, the stock set up isn't too bad.
Quote:
ORIGINAL: TorchRed04GT
Do the 05-07's need MIL eliminators like the 99-04's do?
Only if you're not running a custom tune.
Without either the eliminators or tune, the MIL's will come on anywhere from 50 miles to several hundred miles (that I've been told).
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
RE: Pypes Off-Road H-Pipe Install (w/pics)
