Pypes Off-Road H-Pipe Install (w/pics) - Page 3

Daniel60 · 05-01-2007, 08:35 PM

Excellent Job and ****ing nasty dude but you need 4:10 gears to launch faster.

This ad is not displayed to registered or logged-in members.
Register your free account today and become a member on Mustang Forums!

TacoBill · 05-01-2007, 10:13 PM

Quote:

ORIGINAL: Daniel60

Excellent Job and ****ing nasty dude but you need 4:10 gears to launch faster.

FRPP 4.10's are going in next Monday!

edified · 05-02-2007, 01:30 PM

TacoBill, what axle backs are you using? I like the sound.

[IMG]local://upfiles/37295/D52A1FFD6AB14227A62C34DDF319AE36.jpg[/IMG]

edified · 05-02-2007, 01:31 PM

Never mind TacoBill, I didn't see the header. FRPP Borla rules!!!

0NF1R · 08-31-2007, 09:00 AM

well id love to get this as well but i dont have the tools to install it myself.....have all of your guys installed them yourselves or did you pay someone (how much did it cost if u had them put on)?

Tims07GT · 08-31-2007, 09:02 AM

If you have someone put them on you are looking at an hour of labor. Depending on where you go $65 to $90 an hour.

tritonpwrd · 08-31-2007, 09:30 AM

there are no special tools...i do the swap myself in 45 minutes. It gets too loud for everyday driving so I swap them back and forth when I feel like hearing it.

All you really need is a 15mm wrench for the manifold nuts and a basic socket set.

TacoBill · 08-31-2007, 09:45 AM

Quote:

ORIGINAL: 0NF1R

well id love to get this as well but i dont have the tools to install it myself.....have all of your guys installed them yourselves or did you pay someone (how much did it cost if u had them put on)?

Most allshops won't install any O/R pipes. If it involves dropping the cats, they won't touch it.

DarkFireGT · 08-31-2007, 11:52 AM

Quote:

ORIGINAL: 0NF1R

well id love to get this as well but i dont have the tools to install it myself.....have all of your guys installed them yourselves or did you pay someone (how much did it cost if u had them put on)?

All you need is a socket set, a couple of extensions, and a universal joint (swivel). That, a little patience, and some PB Blaster (or similar) is all you need. I didn't even jack the rear end up to put my on last weekend.

0NF1R · 08-31-2007, 03:48 PM

alright thanks.....

one last thing, what is the diameter difference with the pypes o/r and the stock mid pipe?