Who Has Used Wal-Mart Tint To Tint Tail-Lights?

[iluvmycar]

Has anyone here actually gone and used Wal-mart tint to tint their taillights? If so how hard was it to actually cut the tint and get it to fit and not be a mess or bubble etc? I am not asking anything about VHT night shades. I know about them and know how to do them. If anyone has does this could you tell me how difficult it was and perhaps do a write up on instructions,hints that would make it easier? Thanks!

This ad is not displayed to registered or logged-in members. Register your free account today and become a member on Mustang Forums!

[One Bad Stang]

i didnt do the tail lamps, but i did use cheap tint for the front and rear bumper marker light lenses and the 3rd brake lamp lense. the tail lamps may be quite a bit more difficult because of the uneven surface you will need to cover.

but it was very easy to do on a flat lense like the bumper lights. just use the installation solution and a heat gun/hair dryer and you will be good. and dont forget to get a squeege or an old credit card to smooth it on.

[cobrakiller347]

hmm i would like to do this too

[Joey09]

when you tinted the side markers and that, did you do it on the outside of it and if so, did water do anything to them?