K member and Tq limiter install Question.
#1
K member and Tq limiter install Question.
I installed my k member brace and torque limiters a few weeks ago. I didn't have any real problems doing so except I'm not sure how tight the bushing should have been. That was the only partI found confusing in the directions.
right side bell housing
right side bushings
left side bell housing
left side bushings
I'm thinking the bushing should be tighter. but how much tighter?
right side bell housing
right side bushings
left side bell housing
left side bushings
I'm thinking the bushing should be tighter. but how much tighter?
#4
RE: K member and Tq limiter install Question.
Good install, but i agree that right side bushing is too tight. also did you torque housing bolts to 33lbs only? many confused folks out there over torqued them...
#7
RE: K member and Tq limiter install Question.
also did you torque housing bolts to 33lbs only?
I'd say both bushings are to tight. The bushing should not be wider than the washer. It can cause it to fail.
As always, thanks for everyone's input.
Thread
Thread Starter
Forum
Replies
Last Post