george Dobbs

hello, i have a 2007 mustang that the wife bent the driver rear axle shaft. my problem is im trying to get a new one and im being told its a 28 spline shaft not the 31. Is this true. any help would be appreciated.

scottybaccus

Probably, particularly in the V6. You should be able to find one used pretty cheap. If you are close to a pick-a-part, pull it out and go shopping.

JimC

The V6 Mustang came from the factory with a 7.5" rear end and 28 spline axles (from 2005 through 2010). The GT has the 8.8" with 31 spline axles.

So unless you have changed the rear end to a GT 8.8", you have the 28 spline axle.

For 2011 I believe both have the same rear end and axles.

highline

that's a hellofa first post, lol...hope she got a spankin for that...the above info is correct...that is all

george Dobbs

thanks for your reply, any suggestions as to the best place to get a new axle shaft. I have been looking but i need one with abs or is that something i take off the old one? thanks.

chris09

are you sure its only the shaft? i would check the housing too.

Nuke

I just want to know HOW she bent it...

157dB

You only need the ABS exciter ring if you have a PonyPackage
with the ABS system.
The "base" model V6 didnt come factory with ABS.
You cant remove the exciter ring from the axle without destroying it...

How did she "bend" it
and how did you determine that it is indeed "bent".

george Dobbs

she slid out on a dirt road. went up an embankment. the tire was flat. took it home rotated the wheel and it has a wobble. i am assuming its the axle shaft at that point. vehicle has the pony package. whre is the best place to buy a replacement?

atldave

Someone correct me if I"m wrong here, but isn't this a perfect time to upgrade to an 8.8 and new gears by replacing with a GT rear axle?