Charge Motion Plates - did something stupid
#1
Charge Motion Plates - did something stupid
tl;dr: I FUBAR'd the default position of the CM butterflies. Is there any way to adjust that?
So today I was doing the IAT sensor relocation and everything was going great through most of it. I put the charge motion plates back on after the drilling and tapping and I checked the actuation of the butterflies to make sure everything was aligned properly and make sure nothing was about to get bound up. Well, when I opened the butterflies I heard the motor slip so now the default position of the butterflies is mostly open... So anyone who may know the system is there a way to realign the thing or is this just the perfect time to spring for the Steeda CMDP while everything is torn down?
So today I was doing the IAT sensor relocation and everything was going great through most of it. I put the charge motion plates back on after the drilling and tapping and I checked the actuation of the butterflies to make sure everything was aligned properly and make sure nothing was about to get bound up. Well, when I opened the butterflies I heard the motor slip so now the default position of the butterflies is mostly open... So anyone who may know the system is there a way to realign the thing or is this just the perfect time to spring for the Steeda CMDP while everything is torn down?
Last edited by PSUSkier; 07-23-2011 at 10:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post
bradleyb
Classic Mustangs (Tech)
3
11-27-2015 07:50 PM