2011 Mustang GT Borla ATAK Cat Back Video :)
#13
Oh and Peebz, check out the Ohio Regional Chapter section every now and then. We try to put together some cruises and attend shows every once in a while if you'd be up for it. We might be having something in Columbus on Sept. 17 if you are free. I'm from close to Cleveland and I'm going if you are from around here we could make the trip. Let me know bro and personally I prefer the ATAK over the S type...at least from what i've heard and my understanding of it is the ATAK is more agressive at higher RPMs when compared but i'm no Borla expert.
#14
Thanks for the tips Peez, appreciate it! I'll try the install myself with a jack and stands, if that doesn't work I could probably use the lifts in the auto department at my college. And I know what you mean about reusing the stock couplings when I installed ATAK mufflers on my V6 that I had.
Did you have to torque anything to spec when putting it all back together? Or did you just hand tighten it all?
Did you have to torque anything to spec when putting it all back together? Or did you just hand tighten it all?
#15
Oh and Peebz, check out the Ohio Regional Chapter section every now and then. We try to put together some cruises and attend shows every once in a while if you'd be up for it. We might be having something in Columbus on Sept. 17 if you are free. I'm from close to Cleveland and I'm going if you are from around here we could make the trip. Let me know bro and personally I prefer the ATAK over the S type...at least from what i've heard and my understanding of it is the ATAK is more agressive at higher RPMs when compared but i'm no Borla expert.
I'm actually from Dayton. That wouldn't be too bad of a drive for me.... I"ll PM you if I get serious about going. I'm not sure if I could right now. Thanks for the invite though!
Thread
Thread Starter
Forum
Replies
Last Post