Who is running over 10 pounds of boost on stock bottom end?
#13
I made 474 rwhp and 434 rwtq with an eforce 3.5 pulley, kooks, and detroit rocker cams on the stock bottom end. I never dyno'ed her with the 3.25. The 3.25 made me too nervous so I didn't run it very long.
I would not even chance the 3.0 pulley with the stock rods.
Not really a comparison - I do not have a stock bottom end anymore (plus I added 45 cid & ported FRPP Stage 1 heads) but I picked up around 100 rwhp & 150 rwtq using a 2.75 pulley (and still on the edelbrock 41lb inj).
I would not even chance the 3.0 pulley with the stock rods.
Not really a comparison - I do not have a stock bottom end anymore (plus I added 45 cid & ported FRPP Stage 1 heads) but I picked up around 100 rwhp & 150 rwtq using a 2.75 pulley (and still on the edelbrock 41lb inj).
#14
Heres the link to the B326 thread:
https://mustangforums.com/forum/2005...ml#post8200549
Last edited by jpplaw; 04-24-2013 at 03:09 PM.
#15
I initially didn't make a thread about the installation because I took the car out to Brenspeed and had them swap in the Long Block. I will start one.
Heres the link to the B326 thread:
https://mustangforums.com/forum/2005...ml#post8200549
Heres the link to the B326 thread:
https://mustangforums.com/forum/2005...ml#post8200549
Thread
Thread Starter
Forum
Replies
Last Post
Black_GT_02
4.6L (1996-2004 Modular) Mustang
3
08-20-2015 01:26 PM