Magjackpad

We now have a all aluminum heavy use magnetic jack pad for the mustang almost all other cars with a pinch weld jack point.

They also work great on a lift.

Magjackpad

Here it is on a car pinch weld.

JimC

I measured the opening for the CDC side skirt and it looks like it is 1.5" - I have a picture and will post it up.

Magjackpad

The standard jack pad has a 2 inch opening and they have all been working. Let me know. we make them less than 2 inch 1.85 inch. There are other openings that are smaller, that what you are seeing? we can make them for 1.5 inch also if need be.

what is the CDC skirt? is it a add on?

JimC

Just sent you the pictures - and the side splitter is the Classic Design Concepts (CDC) RTR splitter

6-Speed

What's the distance from the bottom of the pinch weld to the bottom of the jack pad? My 2007 GT500 is lowered and I want to make sure I can wheel my floor jack under the jack pad. I have about 1" clearance between my floor jack saddle and the pinch weld up front and about 1.2" in the back.

Magjackpad

It is 7/8 inch max but around 3/4 inch

05xrunner

I just ordered a set..i got the roush ones I guess ones I was supposed to get since my car has the Roush side splitters
HMMMM So i think its the roush. I bought the car used and didnt even know CDC had splitters that looked exactly the same..guess have to see when they come in

Magjackpad

You will be ok, the Roush will fit all the new Mustangs. So will the Universal. The Roush pad has a shorter outside leg for the push pin and will work fine on a Mustang with out the Roush rockers.

Magjackpad

How did they work out?