transmission/shifter crossthread
#1
transmission/shifter crossthread
So i was installing my new hurst short throw shifter yesterday afternoon and i had the old shifter out and was in the process of bolting the new shifter up. i started with the front connection point. i THOUGHT i had started the bolt right and was just tightening away. a little bit later it got real easy then suddenly theres no pressure. apparently i brok ethe hole that the bolt goes in. SEE PICTURES. any ideas? Feel pretty crappy. such a simply install....
tranny picture is just there to show you where we r. Tranny 2 picture is a close up of our area and the red lines dictate where the thing broke.
Note: the top half of the bolt hole is what broke and is in my hands and is about the size of a quarter just not round
tranny picture is just there to show you where we r. Tranny 2 picture is a close up of our area and the red lines dictate where the thing broke.
Note: the top half of the bolt hole is what broke and is in my hands and is about the size of a quarter just not round
Last edited by cema93; 07-02-2014 at 07:25 AM.
Thread
Thread Starter
Forum
Replies
Last Post
ghunt
2005-2014 Mustangs
3
03-09-2013 06:00 AM
SANANTONIO06GT
2005-2014 Mustangs
15
04-04-2008 02:25 PM
ShadowDrake
4.6L (1996-2004 Modular) Mustang
8
06-09-2007 03:09 AM