GT500 spoiler on 2012 v6
05-31-2012, 09:29 PM
#1
1st Gear Member
Thread Starter
Join Date: May 2012
Location: CA
Posts: 63
GT500 spoiler on 2012 v6
One of the most nerve racking things I have done, drilling holes in my new 2012 black mustang V6. I bought a GT500 style spoiler off of ebay it seemed to fit pretty well when I was sizing it up, it also had a weather strip type seal all the way around. The directions were pretty straight forward and simple but damn its so hard to drill that first hole! I started drilling and then bam! The drill bit broke, WTF??? At least the major damage was on my finger. I drilled the rest (4 total) and lined up the spoiler. One hole was slightly off so I made it a little bigger so the screw fit right in. There cannot be any preasure from one screw or it warps the spoiler. I must say after sweating my *** off it does look good! For everyone out there don't forget to breath.
06-01-2012, 06:05 AM
#2
2nd Gear Member
Join Date: Oct 2004
Location:
Posts: 485
Lol.
I just put the same spoiler on my 2013 and had to drill holes.
My boss came out as I was doing it, and you should have seen the look on his face....
as he shockingly said "you're drilling holes in your new car!!!! I couldn't do that"...priceless
I just put the same spoiler on my 2013 and had to drill holes.
My boss came out as I was doing it, and you should have seen the look on his face....
as he shockingly said "you're drilling holes in your new car!!!! I couldn't do that"...priceless
06-01-2012, 11:34 AM
#5
1st Gear Member
Thread Starter
Join Date: May 2012
Location: CA
Posts: 63
06-01-2012, 03:56 PM
#9
Thread
Thread Starter
Forum
Replies
Last Post
