R1nStang

I bought a 3D Carbon GT500 spoiler from a guy on CL. IT doesnt have the screws with it, but the spoiler does have threaded inserts already inside it. I dont know where he ordered the spoiler from he said he bought it from someone else on CL but decided to sell it since he found another one painted the color he needed. Does anyone know what size screws I need? I tested one laying around the other day. Im sure its an M6...but what about the length of it?

Cruzinaround

The OEM threads on the decklid studs that should have been on that spoiler are 6mmx1.0.

Not sure what the size is going into the spoiler M6 sounds right but you'll need to do a physical check with a stud from a local hardware store. These studs extend into the decklid about 2 inches.

---

R1nStang

ok cool man. so i need about 2 inches of stud sticking out from the spoiler...correct? ill hit up the hardware store after work...just wish there was one between work and my house....not 15 miles past the house haha....but im on the motorcycle..so fun ride!

Cruzinaround

Yup....that'll do....

Also, if you don't already have a spoiler... You'll need 4 holes on the trunk. Otherwise the stock locations should line right up.

R1nStang

got the stock lip spoiler. so holes are predrilled...thank god...i dont wanna drill my car

R1nStang

just for anyone else needing to replace the screws I used M6 threaded rods cut at 20mm length. Ace hardware carries them. you can reuse to stock nuts.