rear end diagram
#3
RE: rear end diagram
Thanks
Unfortunately that one doesnt show the inside of the housing and how stuff goes in though.
Im trying to see how the axles are held in place and where the pins and clips go.
Unfortunately that one doesnt show the inside of the housing and how stuff goes in though.
Im trying to see how the axles are held in place and where the pins and clips go.
#6
RE: rear end diagram
its really simple to pull the axles. it will prolly take like 15 min for a first timer.
1. support on jackstands
2. pull the rear wheels and drums
3. take off the diff cover and drain the fluid
4. loosen the bolt and take out the little shaft in the dif (not sure what its called it just 1 bolt and its a metal shaft maybed somebody can help me out)
5. after you remove that have a buddy push in one of the axles a littel bit
6. pull the C clip out w/ some pliars
7. slowly remove the axle
over all its really really easy. good luck
1. support on jackstands
2. pull the rear wheels and drums
3. take off the diff cover and drain the fluid
4. loosen the bolt and take out the little shaft in the dif (not sure what its called it just 1 bolt and its a metal shaft maybed somebody can help me out)
5. after you remove that have a buddy push in one of the axles a littel bit
6. pull the C clip out w/ some pliars
7. slowly remove the axle
over all its really really easy. good luck
#8
RE: rear end diagram
yeah you shoulnt have a problem with it. as long as you have some idea of what you are doing you should be fine. also a chilton manual would be pretty helpful if you dont have one already.
Thread
Thread Starter
Forum
Replies
Last Post
Dragonus18
4.6L (1996-2004 Modular) Mustang
8
09-09-2015 01:21 AM
tj@steeda
Steeda Autosports
0
09-01-2015 08:16 PM