351 OR 408 STROKER MOTOR.
#1
351 OR 408 STROKER MOTOR.
me and my friend are about to go buy a foxbody mustang rolling chassis.
we want to build this as a drag car.
we were thinking of putting a 351 or 408 stroker motor in it. cant decide.
we are both 17 years old but his dad is planning on helping us. we want to turbo it and make about 700-1000hp. what motor should we go with.
we want to build this as a drag car.
we were thinking of putting a 351 or 408 stroker motor in it. cant decide.
we are both 17 years old but his dad is planning on helping us. we want to turbo it and make about 700-1000hp. what motor should we go with.
#3
That's exactly what we were thinking cause if we would go with the 408 with turbo we would never be able to put the power to the ground. What numbers would we be looking at with these mods
1992 foxbody 351 stroker built motor aluminum everything hellion single turbo 15psi with supporting mods
Full exhaust
Custom long tubes
3" x pipe
Full 3" catback
Rolled fender to lower and fit 28" slicks.
Drag launch springs
Line locks
Aluminum driveshaft
Built auto trans
Ford racing 9" rear axle
Mickey thompsons 28" slicks
15" aluminum wheels.
we are looking to make about high to mid 9 seconds with this set up.
1992 foxbody 351 stroker built motor aluminum everything hellion single turbo 15psi with supporting mods
Full exhaust
Custom long tubes
3" x pipe
Full 3" catback
Rolled fender to lower and fit 28" slicks.
Drag launch springs
Line locks
Aluminum driveshaft
Built auto trans
Ford racing 9" rear axle
Mickey thompsons 28" slicks
15" aluminum wheels.
we are looking to make about high to mid 9 seconds with this set up.
Last edited by EddyG; 01-19-2012 at 08:38 AM.
Thread
Thread Starter
Forum
Replies
Last Post