Sure your going to have some clearance problems. The engine will most like sit about 1.5 inches higher than a 302. Your talking a 9.5 deck height VS. an 8.2! You'll most likely run into header clearance issues. But it's a common swap. I think you'll want to change the motor mounts. I also think a oil pan swap is needed. There's probably a ton of guys that have done the swap in this section that can answer the question but I don't think you just drop in a 351. Good luck.
363 fully forged dart engine on the way with more spray!TRANNY
C4 with trans brake, 3800 stall, 9in. raceconverter, hurst shifter REAR
Moser 35 spline kit with spool, FRPP 3.73 gearsSUSPENION
UPR pro street Uppers & lower control arms, Strange 10 way dampers, coilovers up front, BBK sub frame connectors, UPR Tube K-member & Afirstname.lastname@example.org (OLD 5.0)
2011 CamaroSS email@example.com