07 harmonic balancer torque?
#2
#3
Sorry for posting to old thread but it's TTY M12x1.50 bolt and cannot be reused. Need to replace every time. Torqued in stages 33 ft-lb then turn additional 85 degrees. Use old serpentine belt turn inside out and wrap around pulley and over adjacent pulley to hold engine from turning on automatic car. Can also use a strap wrench to hold HB. The new HBs are fully vulcanized and less likely to fail than the factory original
Last edited by bfunke; 06-14-2015 at 08:52 PM.
#4
Sorry for posting to old thread but it's TTY M12x1.50 bolt and cannot be reused. Need to replace every time. Torqued in stages 33 ft-lb then turn additional 85 degrees. Use old serpentine belt turn inside out and wrap around pulley and over adjacent pulley to hold engine from turning on automatic car. Can also use a strap wrench to hold HB. The new HBs are fully vulcanized and less likely to fail than the factory original
where can I buy the new bolt
Thread
Thread Starter
Forum
Replies
Last Post
Marky82
V6 S197 General Discussion
2
10-09-2016 06:19 PM