rookie mistake - driveshaft
#1
rookie mistake - driveshaft
replacing my clutch on my '05 V6. I removed the driveshaft, but didn't pay attention to which end was attached to the tranny, and which to the rear end.
1. Does the orientation matter?
2. If so - can anyone clue me in on which end is which?
If it matters - one half is nice and smooth (round), and the other half is ridged...
Thanks in advance.
1. Does the orientation matter?
2. If so - can anyone clue me in on which end is which?
If it matters - one half is nice and smooth (round), and the other half is ridged...
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
2.3L Eco-Boost Tech
2
11-24-2015 06:11 AM
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM