4.6L (1996-2004 Modular) MustangTechnical discussions on 1996-2004 4.6 Liter Modular Motors (2V and 4V) within. Sponsored by Cruizin Concepts
Welcome to Mustang Forums!
Welcome to Mustang Forums.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
You can go from the back bottom, there is a small jack that you can get to the 8mm nuts I believe. You just have to worry about snaking your hand up into there. If you can not, then you will have to remove the bumper.
i just removed one of the 8 mm bolts, then broke off the the other. i take it that your installing clear ones? i put the new ones on with one bolt and some clear silicone. it works just fine, and they arent going any where.
99 gt, vortech-12psi, lentech with 3000 stall, 3.73's, detroit locker, headers, bassani x-pipe, flowmasters, predator custom tune,
Ok, thanks for the replies. Actually im takin the factory ones out, wetsanding the letters off of them, and Im gonna spray the nightshades and clear/wetsand them. Ill just save it for a winter project...
Sig pic size limit is 250px high by 500px wide. Admin
03 GT 5 speed N/A..TFS heads, etc...firstname.lastname@example.org w/1.59 60ft.
This forum is owned and operated by Internet Brands, Inc., a Delaware
corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford
Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor