Mac Pro Chamber Install
03-12-2008, 07:12 PM
#1
1st Gear Member
Thread Starter
Join Date: Feb 2008
Location:
Posts: 99
Mac Pro Chamber Install
Just got my Pro Chamber today and was planning on installing tomarrow. I have a stock exaust which is 2 1/4" and the Pro chamber is 2.5". Will this bolt right up? It dont look like the stock catback will mate with the larger Pro Chamber. Any help or tricks would be appreciated....especially the passenger side mainifold to H pipe connection....it sure looks tight to get a wrench onto.
03-12-2008, 07:33 PM
#2
5th Gear Member
Join Date: Nov 2006
Location: So Cal
Posts: 3,569
RE: Mac Pro Chamber Install
ORIGINAL: 02TorchRedGT
Just got my Pro Chamber today and was planning on installing tomarrow. I have a stock exaust which is 2 1/4" and the Pro chamber is 2.5". Will this bolt right up? It dont look like the stock catback will mate with the larger Pro Chamber. Any help or tricks would be appreciated....especially the passenger side mainifold to H pipe connection....it sure looks tight to get a wrench onto.
Just got my Pro Chamber today and was planning on installing tomarrow. I have a stock exaust which is 2 1/4" and the Pro chamber is 2.5". Will this bolt right up? It dont look like the stock catback will mate with the larger Pro Chamber. Any help or tricks would be appreciated....especially the passenger side mainifold to H pipe connection....it sure looks tight to get a wrench onto.
Get some PB blaster, a few extensions, a swivel socket, a lot of leverage and every swear word you can think of and that should do it. An impact gun will be a massive help....
Search next time. This gets asked every other day.....
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM
tj@steeda
Steeda Autosports
0
09-10-2015 08:39 PM
