gasket matching stock TB and plenum?
#1
gasket matching stock TB and plenum?
Not sure how it flows but I did a gasket match on my stock tb and plenum. I could tell were all the gaskets had been sitting so I smoothed out all the transitions and sanded the whole internals smooth.
Has anyone else tried this or seen dyno numbers or a flow chart on this?
Has anyone else tried this or seen dyno numbers or a flow chart on this?
#3
I know getting air flowing in smoothly is as important if not more than getting a lot of air in to keep velocity up. I know with my silverado porting and polishing the stock throttle body seemed to make a difference. But that throttle body could also handle my mods.
Thread
Thread Starter
Forum
Replies
Last Post
AmericanMuscle4.6GT
2005-2014 Mustangs
7
11-10-2015 02:06 PM