Heads,cams and headers
#1
Heads,cams and headers
So I just paid off my 2004 mustang GT convertible and I'm looking to upgraded the motor and get a lot more power out of it. So I was going to start with heads a cam and headers. Do any of you know the best bang for the buck. Or a good setup that will produce good power upgrades. Thanks ahead for all the imput and help given. Thanks chris.
#2
Well what are you goals for this car?? You wantin to run Nitrous? Supercharger? Turbo?
On the stock block you're gonna be limited on the cams you can use due to clearance issues...Right now im at a forged shortbock w/ -11cc pistons, Trickflow 44cc heads, and Hitech stage 2 cams and Edelbrock intake...at am at 306hp/280tq. With the lower compression motor my numbers are a little lower than if you did a high compression motor...but im building for a turbo i have goin together.
Figure out what you want out of the car because heads/cams aren't something you want to spend $$ twice lol...
On the stock block you're gonna be limited on the cams you can use due to clearance issues...Right now im at a forged shortbock w/ -11cc pistons, Trickflow 44cc heads, and Hitech stage 2 cams and Edelbrock intake...at am at 306hp/280tq. With the lower compression motor my numbers are a little lower than if you did a high compression motor...but im building for a turbo i have goin together.
Figure out what you want out of the car because heads/cams aren't something you want to spend $$ twice lol...
Thread
Thread Starter
Forum
Replies
Last Post
junior04
4.6L (1996-2004 Modular) Mustang
1
09-28-2015 10:53 AM