scooter3

Can I tie right into the vacuum line that goes to my BOV for an accurate vac/boost reading or is there a better place to tie into?

bopiela

glad you asked. My gauge will be here today! haha.

disposablehero27

Also glad you asked. I have mine and no idea where i should run it. I figured somewhere in on or around the intake. Drill and tap kind of thing. But i dont know

scooter3

Well I am going to try it. I can't think of any reason why it would not work. Alot of guys run it off the drivers side fuel vac relay or off the TB. The cav hose going to my BOV is coming right off my lines from the TB.

uberstang1

I got mine spliced into a line right off the manifold, works fine. Definatly no need to drill and tap the intake

scooter3

Worked like a charm. Vac shows around 19 at idle and boost climbs when I get on it.

dwtjr3

This is what i did, spliced mine in right around my TB and works fine

MustangMan00

mines spliced into the fuel pressure sensor on the drivers side

disposablehero27

dwtjr3, where on the TB? Mine is a mechanical gauge... not sure if everyone's is here or not. i just have the clear vac line, with no clue where to put it on my 96 cobra.

MustangMan00

the top right of the pic, do you see the clear line coming out of the firewall?

follow that down to the white T fitting, coming off of the fuel sensor, this is a common spot to hook em up at

or the red wires coming out right after the throttle body