car keeps stalling.
#1
car keeps stalling.
I bottomed the car out about a month ago and f'd my starter wire and ground wire for the motor to body. I replaced both of the wires and now, when I just start the car it dies every time I hit the breaks. When the cars warmed up it will only stall when the brakes are hit hard. When its warmed up I can coast then slowly apply pressure to the breaks with out stopping. I also noticed that after a wot pull the car will die when I let off then it will start back up. The cars a stick and yes I am pressing in the clutch every time I stop. I've tried raising the idle but that didn't help.// Anyone have any ideas at what could be causing my problems?
#4
Hmmmm.
My car did the same thing you are describing but i am a out. When ever i would hit the brakes hard it would stall (only time it would stall tho wouldnt stall when it was cold) And it ended up being a tuning issue. My tuner adjusted the vacuum a little bit and fixed it. That is why I asked if you had a vacuum leak.
I am not sure what all to as you to check tho.
Did the hot wire come off of the starter when you bottomed it out? Like the power wire
My car did the same thing you are describing but i am a out. When ever i would hit the brakes hard it would stall (only time it would stall tho wouldnt stall when it was cold) And it ended up being a tuning issue. My tuner adjusted the vacuum a little bit and fixed it. That is why I asked if you had a vacuum leak.
I am not sure what all to as you to check tho.
Did the hot wire come off of the starter when you bottomed it out? Like the power wire
Thread
Thread Starter
Forum
Replies
Last Post
92 5.0stang
5.0L (1979-1995) Mustang
4
08-13-2015 06:46 AM
Milan Dragway
Members Rides and Car Show Section
0
08-12-2015 03:43 PM