4.6L General DiscussionThis section is for non-tech specific information pertaining to 4.6L (Modular) Mustangs built from 1996 to 2004.
Welcome to Mustang Forums!
Welcome to Mustang Forums.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
No front plate needed here, but if it was I would fabricate something like that. Most h/w stores have 1/8" x 3/4" or 1" flat stock, and the slots would not be needed for custom brackets--in fact they could likely be once piece for our cars.
Something to keep in mind; aluminum flat stock does not tolerate sharp 90° bends without fracturing, make it a radiused band (1/4" or better) or two closely spaced 45° bends...
They have something like that on AM. Yes you have to drill but you can tuck it under your car when you're at a car show, or in a different state. I have one on my car. That's why I was able to mount it at the bottom of my front bumper. See pics below. I had it mounted on my bumper (had to drill holes into it). Now bottom pic I mounted it on the bottom of my bumper and can actually slide it up under my bumper if need be.
Drilled into the bumper
Vortech V-1 T Trim SC (intercooled)
HP 292 cams
Teksid Forged Short Block 433 RWHP/390 RWTQ 3.33 pulley
New Project: MMR 900 Shortblock/2.87 pulley/465 RWHP or bust!
This forum is owned and operated by Internet Brands, Inc., a Delaware
corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford
Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor