Bman2000

Dyno time is next Saturday, anyone care on putting their guesses in? Been building this thing for 3 years now. ill give you the run down.

V1 Si trim 3.33 upper, factory lower
Home made 4 inch power pipe
Tread stone FMIC matched and welded ic tubing
Tial 50mm bov
hpx slot maf
42# injectors
Ford gt super car pump, pprv delete.
Weapon x cops w/ low impedance spark plugs
75mm TB, tb matched upper intake, typhoon intake manifold w/ gasket matching
Heads have been hand blended to match intake gaskets
factory headers, catless bassani x pipe w/ 12" bullit style glasspacks.
Egr delete, pcv bypass into a catch can
Sct hand held

t-56 swap with fidenza lightened flywheel, 3.90 gears


So any guesses as to what boost ill see and what power numbers people think i will get if it doesnt blow up on the dyno? haha

TRexGAWD

Bout tree fiddy man...

Gt04

415/400

Bman2000

rex your killing me, like im not nervous enough haha

TRexGAWD

Haha, I think you'll be alright.. 3.33 pulley is like what 8PSI or so? With that I'm seriously guessing around 380 wheel.. Stock block? No cam or anything?

Bman2000

3.33 is a 10psi i believe, of course that all depends on what the IC restricts, ect. and yes stock block, on a fairly fresh rebuild though. no cam, just the mods i mentioned basically.

Soldier GT

Got a pardner with pretty much your same setup and he made 378/358 to the rear wheels. Make sure you post a vid and good luck!

Bman2000

just watched kerns vid, from what i read, he has everything i do, except i have the ford gt pump and no bap. and he made 402 so thats what im dreaming for right now. I dont know if he has a power pipe though?
soldier who made that? and whats their set up?

ill post a vid if i can get someone with a camera to come....cars to loud for my phone, blows out the speakers now that i dont have the cats in anymore.

Soldier GT

A guy in my car club. He hhad LT's though but I see you have a aftermarket intake so it should be close. You're also right. A 3.33 pulley will push you at or around 10 psi. All I can say is be careful.

TRexGAWD

I thought Kern at a T-Trim? Those flow a bit more up high IIRC