Tim99GT

Does anyone have any mounting solutions besides the spare tire well for these (Minus BAS)?

I'm not against utilizing the tire well since i done keep a spare tire in there anyways. Just looking to see if anyone has done anything different.
If you have any pics, post them up

Thanks

WhiteFoxGT

IIRC, doesnt the harness run along the driver side truck liner, up against the quarter panel? My buddy's car had a BAP(the poverty one) and I swear we mounted it there and tied into the harness. But this was 3 years ago so I might be off

Tim99GT

It does. When i had my KB 2.1 i mounted the BAP on the bracket on the driver side rear panel. This time however i will have the BAP and Zone 5 Module to wire up and was looking to put them together. I guess ill have to take a look at it this afternoon and figure out what im going to do as far as mounting location. I don't think there is enough room on the bracket to mount both.

Link to BAP install just for info:
KB BAP Install

Tim99GT

Mounted the zone 5 and KB BAP. I ended up making some brackets with flat aluminum to secure the MDM jr and mounted the BAP where i had previously mounted one (from when i had the old KB 2.1)

Pics: