BBK L/T headers
#1
BBK L/T headers
I have BBK long tube headers on my 03 GT and they just look like they are really low, close to scrubbing the ground. Yes i do have H&R lowering springs but i just feel like they are hanging to low. Its the only thing that scrubs when i go over speed bumps. Does anyone else ahve this problem??
#2
A lot of pple with long tubes and lowering springs have this issue .
I don't ever go any where that has speed bumps , or havnt yet since my long tubes but I expect that if I did they would scrape some.
My car is lowered 2 1/4" with some obx longtubes , im pretty sure the obx are just bbk knock offs
I don't ever go any where that has speed bumps , or havnt yet since my long tubes but I expect that if I did they would scrape some.
My car is lowered 2 1/4" with some obx longtubes , im pretty sure the obx are just bbk knock offs
#4
OP,
Unfortunately, this is a common concern with LT's on SN95 Mustangs. I had the same problem with my H/C/I '95 GT, so I had to be aware of the routes I was driving. However, to me the Pro's out weighted the Con's... Everyone is different though!
Shane
Unfortunately, this is a common concern with LT's on SN95 Mustangs. I had the same problem with my H/C/I '95 GT, so I had to be aware of the routes I was driving. However, to me the Pro's out weighted the Con's... Everyone is different though!
Shane
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM
junior04
4.6L (1996-2004 Modular) Mustang
1
09-28-2015 10:53 AM