P1720 output shaft speed sensor
#1
P1720 output shaft speed sensor
Good morning. 98 gt automatic. I recently got the code P0720 after noticing that the od off button was flashing and the check engine light came on. I switched out the part from oreillys and I still get the flashing light. Is there anything else that might cause that code? Or does ir have to drive a few miles for the computer to recognize the new part? Thx Gordon
#2
Assuming you replaced the correct sensor. And the problem persists, next step would be to check the harness and main connector for issues. If there is an internal problem in the trans throwing the 720 code you'd most likely have other transmission codes associated with it
#8
not a fluid issue. and a cheap scanner will most likely not be able to pull all the codes. there may not be any more codes....however if the wiring is all intact and allow continuity, you could have an internal transmission issue.
Thread
Thread Starter
Forum
Replies
Last Post
trashxtrash
4.6L (1996-2004 Modular) Mustang
4
09-20-2015 10:49 PM
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM