Running EEC-V Self Test
#1
Running EEC-V Self Test
Hi,
I have just got a 1997 Ford Thunderbird LX with a 4.6L V8 Running EEC-V management.
I have connected my laptop to it using a cheap OBD2 to USB cable from Ebay, and run a few programs. I can see there are no fault codes and see some of the engines parameters.
What I would like to do is run a self test. I used to have a Ford Granada Cosworth which ran EEC-IV management and it was possible to do KOER and KOEO tests on this by shorting a pin on the self test connector.
How can I run similar tests with EEC-V? I noticed in the glove box there is a connector which says "ARK/EVO Test" and it looks like a Self Test Output connector according the Ford Fuel Injection site. Do I need to sort some pins on this connector? Or is it possible to start a self test running from my laptop?
Thanks
I have just got a 1997 Ford Thunderbird LX with a 4.6L V8 Running EEC-V management.
I have connected my laptop to it using a cheap OBD2 to USB cable from Ebay, and run a few programs. I can see there are no fault codes and see some of the engines parameters.
What I would like to do is run a self test. I used to have a Ford Granada Cosworth which ran EEC-IV management and it was possible to do KOER and KOEO tests on this by shorting a pin on the self test connector.
How can I run similar tests with EEC-V? I noticed in the glove box there is a connector which says "ARK/EVO Test" and it looks like a Self Test Output connector according the Ford Fuel Injection site. Do I need to sort some pins on this connector? Or is it possible to start a self test running from my laptop?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM
tj@steeda
Steeda Autosports
0
09-08-2015 11:50 AM