Just Purchased a 2.3 Whipple super charger
#1
Just Purchased a 2.3 Whipple super charger
Just purchased a 2.3 Whipple super charger to go on my 2007 Mustang GT Prem. Can't wait the excitement has already started building up.
KIT INCLUDES
- Polished Manifold
- Ford racing/Whipple 2.3 supercharger
- Steeda 10 rib belt drive system w/18lb pulley
- powder coated intake w/ K&N
- Custom built plentum 2x stock size
- Stock plentum
- Heat exchanger/Intercooler
- Fore precision fuel rail w/75# injectors
- Stock fuel rails
KIT INCLUDES
- Polished Manifold
- Ford racing/Whipple 2.3 supercharger
- Steeda 10 rib belt drive system w/18lb pulley
- powder coated intake w/ K&N
- Custom built plentum 2x stock size
- Stock plentum
- Heat exchanger/Intercooler
- Fore precision fuel rail w/75# injectors
- Stock fuel rails
#5
Yes it was used for 1000 miles..I'm not going to run more then 8# it just came with what is listed. I'm getting the Ford Racing M-9407-GT05 fuel pump. Also I'm going to have Injected Engineering do the install and tuning.
#7
Cool! That's the fuel pump that came with my kit. I'm guessing the 10 rip kit comes with a stronger tensioner, otherwise you should get one of those too. Also consider getting an oil separator (aka catch can). Get spark plugs too. Awesome, you're going to have fun with that. I just installed mine about a week ago and it's a blast. Way too easy to spin the wheels.
#8
congrats on the blower.
seeing you have the steeda 10 rib kit, you'll need another bigger SC pulley instead for the stock block.
the 3.5" is rated at 10 psi for the gen 2 Whipple.
for 8 psi, you may want something a tad bit larger.
HT0 plugs?
seeing you have the steeda 10 rib kit, you'll need another bigger SC pulley instead for the stock block.
the 3.5" is rated at 10 psi for the gen 2 Whipple.
for 8 psi, you may want something a tad bit larger.
HT0 plugs?
#9
I'm having the 10 rib removed and replacing it with WHIPPLE-PULLEY0507GT - 3.625" 8-9 psi. Injected Engineering supplies the spark plugs and coolant, but I will definitely check on the oil separator.
Anything else you can think of that I need to add to my list of parts?
Anything else you can think of that I need to add to my list of parts?
#10
If they're removing the 10 rib then I'd put on a stronger tensioner. The guys at Injected Engineering can confirm this but, I think with the 3.625 pulley you'll want a 90mm tensioner and 90mm idler pulley. The stock idler pulley is 90mm. The stock tensioner is 76mm so I recommend getting the Thump Racing tensioner part number PM-1002-90 which comes with a 90mm. The belt size I believe would be 124.7