C10
#1
C10
Off topic - C10 forums do not have the activity this place does.
I have a 85C10 with a supposed stroker motor. (I have not pulled pan to read numbers on the crank to verify.) I am having a tough time getting it running/starting.
Checked compression yesterday. All read 123-125 PSI EXCEPT #2 reads 160. When pulling the plug out the cylinder #2, it was full of gas. Assuming I will need to buy plugs again... Any ideas what can cause this so I do not blow out more plugs? Cannot get it running right.
I have a 85C10 with a supposed stroker motor. (I have not pulled pan to read numbers on the crank to verify.) I am having a tough time getting it running/starting.
Checked compression yesterday. All read 123-125 PSI EXCEPT #2 reads 160. When pulling the plug out the cylinder #2, it was full of gas. Assuming I will need to buy plugs again... Any ideas what can cause this so I do not blow out more plugs? Cannot get it running right.
Thread
Thread Starter
Forum
Replies
Last Post
FBStang82
Archive - Trades & Freebies
4
11-25-2007 09:07 PM