MustangForums.com

MustangForums.com (http://mustangforums.com/forum/index.php)
-   4.6L V8 Technical Discussions (http://mustangforums.com/forum/4-6l-v8-technical-discussions-69/)
-   -   2006 GT 5spd will not come off Motor! (http://mustangforums.com/forum/4-6l-v8-technical-discussions/704378-2006-gt-5spd-will-not-come-off-motor.html)

gpoetx 12-14-2013 03:49 PM

2006 GT 5spd will not come off Motor!
 
Ok, all 9 bolts are out, Starter out, driveshaft off, shifter out, hydraulic line off, sitting on transmission jack and this trans will not come off.
I shook it, tapped it a few times with a hammer but not too hard, grabbed a pry bar and lightly tried that and won't budge.
Did I forget something???

Mustang Matt 12-14-2013 09:45 PM

Sometimes they're stuck on there pretty good. When I took mine off I left the hydraulic line on and pushed the clutch in a few times and that helped separate the two a little. Then I was able to gently pry it the rest of the way.

tx_zstang 12-24-2013 02:49 AM

It can be difficult for it to separate along the dowel pins. Some powerblaster will help break loose any grime or rust. But eventually, using a pry between the engine and trans will be needed. had one like that earlier this year. Eventually separated it.

CPTCO 12-24-2013 10:07 AM

Get one person on the tail of the tranny wiggling it, and one up by the motor prying and pushing. It will come.

JCON 12-30-2013 07:53 PM

Quote:

Originally Posted by CPTCO (Post 8326352)
Get one person on the tail of the tranny wiggling it, and one up by the motor prying and pushing. It will come.

Is that what she said? ;)

pascal 12-30-2013 09:01 PM

Quote:

Originally Posted by JCON (Post 8328876)
Is that what she said? ;)

In that case, that's what HE said. lol.

CPTCO 12-30-2013 09:10 PM

Where did this guy go? I guess he either got it done, or the tranny is laying on top of him...

tbear853 12-31-2013 12:17 PM

1 thread, only 1 posts, two weeks ago ....

.... maybe someone should go check on him? :D


All times are GMT -5. The time now is 05:14 PM.