Mellowdien

Hey Guys,

I've been looking for a nitrous plate for my somewhat "custom" nitrous set-up. I use mostly ZEX components. The nitrous plate has to be able to fit with my Ford Racing Throttle Body and stock intake manifold (preferably also a Ford Racing Intake Manifold as i might be upgrading in the near future).

I've been spraying a 100shot. Want to go up to 150 but prefer to do so with a plate.

I've spoken with a few manufacturers but none can be sure whether or not it will fit the with aftermarket throttle body or in the future with an aftermarket intake manifold.

Any suggestions?

Evo2s197

I don't see why the below setup wouldn't work with the FRPP IM, if anything you might have to rebend the hard lines on each side or get new one as the FRPP is a tad bit wider and taller. As for any after market TB not sure about that because the plate systems available are port matched to the factory size.
http://www.nitrousoutlet.com/efi-wet...allery-image-4

kwhodson

Did you ever find this? I am running the FRPP 62mm throttle body and the FRPP intake...I want to use the NX Plate system

Mellowdien

Hodson, no i've stuck with the current "hole in the intake" system for now. It works fine with the 100shot. Most people just advised me to use a plate when going above the 100shot as it might have some issues due to the throttle bodies being dual and not mono.

I have purchased a nitrous outlet plate. I'll start playing with it as soon as it gets here. But if you beat me to it, please share!