wont start after plug and wire change...
#1
wont start after plug and wire change...
firing order is 1,3,4,2 right? and cylinder one is the closest to the front so....what the hell happened here? all i did was change the wires and plugs, and now it wont start... is the firing order still wrong, or did the ignition module go on me...?
#2
RE: wont start after plug and wire change...
did you hook them on the distributor in the right spots.... i never had a distributor 2.3L, only EDIS system. i think #1 was closest to you and the right when looking at it.... not 100% positive though.
#4
RE: wont start after plug and wire change...
hah ignition module didnt go out...u probably put them in the wrong spots..if it turns over then ur fine just dick around with the wires til u get the right spots it ges 1 3 4 2 clock wise
#5
RE: wont start after plug and wire change...
i just changed my distributor and wires today..ill draw a pic of how the wiresshould be connected haha sorry for the crappy paint pic.
http://img471.imageshack.us/img471/3412/67369244ha1.jpg
http://img471.imageshack.us/img471/3412/67369244ha1.jpg
#9
RE: wont start after plug and wire change...
ORIGINAL: damoney69
there hes is a diagram the circle isdistriband rectangle is yourcylinder
The edis is WRONG!!!!!
Level, wheres the pic i drew u for the EDIS system, cause there is two ways, 91-92 had one way, and 93 had 3 and 1 reversed. find that pic and upload it here
there hes is a diagram the circle isdistriband rectangle is yourcylinder
The edis is WRONG!!!!!
Level, wheres the pic i drew u for the EDIS system, cause there is two ways, 91-92 had one way, and 93 had 3 and 1 reversed. find that pic and upload it here