sleeper_inc

How to re-pin a harness. I'm using a 1989 harness from a 2.3 manual car. It should be the same for a 1987-1990 mustan with either a auto or manual transmission (since its only the computer to engine bay harness)


This is a wiring harness out of a 1987-1990 mustang 2.3. Its the computer to engine bay harness.



The protective black case on top helps stop the pins from backing out and also protechs them from rubbing on metal and shorting out.


Here I took the case off to get at the pins using a small screw driver.


Another way of keeping the pins in is this red casing. Remove it using a small flat headed screw driver with a back and forth motion (like in the next picture)




The inner casing has been removed, and now the pins are ready to be removed.


**Make sure to number what side has what number of pin to make it easier to see where the pins go (trust me, this helps alot because then you don't have to move the harness back and forth between yourself and the computer).


I found using a small zip tie works well for taking the pin out without damaging it in any way shape or form.



List what color wire is going to do what (stops you from getting confused and wiring it incorrecty)(Quilty of doing that)





This is how I joined the two wires without cutting a connection. Stip the insolation off the wire being connected (about a 1/4") then strip and cut about the same from the wiring being connected to. Then solder the joints together, and then tape to keep them from touching, causing them to short out.


Since my wiring harness was out, I connected them higher up to make it cleaner and look stock(ish).


Had to drill a hole through the gromit because of the gauge of wiring I used, but its also a blessing because it made it easier to move the wiring closer to the wall for a mounting point.


I also deleted my A/C condenser and clutch lines since I longer want A/C


Wiring all together and ready to be installed

Stang2.3

Awesome bro.... Now about how long do these wire need to be?

sleeper_inc

I made mine about 7 feet, and I cut the extra off

Stang2.3

Sweet.... so now i need wire.......

Stang2.3

bump...... workin on wiring

Stang2.3

havin problems takin the pins out.... how you get them out??

sleeper_inc

I used a zip tie, shoved the little pointed end into the clip holding the pin inplace.

Stang2.3

i got em thankz bro!

sleeper_inc

No problem, its alot easier to do it this way that with something metal. Plastic bends, metal dosen't[&:]

Stang2.3

No Problem.... so all i need to wire is four wires???