94gtcobra

I just got some equal length headers for my 94 gt for $50 with the egr on the header. I was wondering how hard are they to install. What do i need to remove or modify to fit these. DoI neednew shorter spark plugs and wires?Any pictures of installation or a car that has some are helpfull.

jnsnams

on my 95 i got one in from the top and one from the bottum side and that was it, bbk makes there headers easy to put in and you dont have to change anything really....but without the model number on them i cant but really striaght with you, all i can say is mine fit perfect in there and i didnt have to change a thing..

OneFastEclipse

The Drivers side is going to be the hard one. Don't even bother trying to bring it up from the bottom on the drivers side, it will hit the steering shaft. Be ready to unbolt the motor mounts and jack up the motor.

jnsnams

on mine i didnt have to raise the motor at all, it slid right into place? same when i toke mine out slid right out too..

OneFastEclipse

Are yours equal length?

jnsnams

i think mine were equal,ive done both and never had to lift the motor up..

94gtcobra

So do i have to take the air condition hoses, the strut sway bar on top, the smog pump lines. Also i do have to jack up the motor, damn, i should also change my motor mounts because my car shakes at idle also and engine shakes.

94gtcobra

These are the headers.

jnsnams

the strut bar needs to come out for the install, air hoses dont have to be moved or anything like that or the smog lines, if the motor and stuff is shaken i would change out the motor mounts and to be on the safe side the trans mount also with it, get a package deal about it...

jnsnams

those are shortys man, put them in nothin has to be moved or anything, go do that now they bolt right to your factory exaust...