94StinkinLincoln

im rebuilding my 302 and gonna bore itto a 306 then put a b303 cam and aluminum heads. friend said it could get close to 250rwhp. is this accurate? and will the setup work good for a street and stip weekend car? its a 95 mustang gt

92hatchLX

Depending on the heads that you go with, a good H/C/I is worth any worth anywhere from 260-300+ horsepower. I'd also do an intake.

94StinkinLincoln

what would u recommend that would go with the b303...as far as the heads and intake manifold?
also would i need to upgrade anything else on the car w/ these upgrades?

VigCS

Everybody will say afr or trick flow heads, but if you're on a budget GT40s are thumper E7s will get the job done well.

The trick flow street heat is a nice intake, though.

BlackLX

What heads were you going to go with originally?

94StinkinLincoln

wasnt quite sure...i was thinkin gt40 but friend says aluminum is the way 2 go

iceman89gt

got a holley systemax 2 on my 306 and im at 337 horses plus , runing mid 12s in the quater at 110 to 112 mph. check it out below on film

http://www.youtube.com/watch?v=Ceg21BoOTw4

94StinkinLincoln

very nice! i have a 95' w/ an auto tranny...what do u think it would run?

just a peice of unuseful info...my 94' towncar w/ 4.6L runs 16.1..its an auto that ways 4,xxxlbs lol

iceman89gt

whats the 95 stang weigh and what stall is on the tranny also what gears are in the rearend

94StinkinLincoln

weight is about 3400..its a stock tranny but im gonna have it rebuilt b/c its not running quite right...im gonna get a shift kit for it and its got stock gears...not sure if im gonna change that part just yet.