Riverside, CA 5.0 Rebuild Help
#1
Riverside, CA 5.0 Rebuild Help
Hey everyone, i figuered this would be a good place to ask. I want to have my 1990 302 rebuilt and have new heads installed. Where is a good place in Riverside Area So Cal to have this done? Thanks again.
#3
RE: Riverside, CA 5.0 Rebuild Help
Cant hurt to get some buisness names if its not too much trouble from ya. I just wanna get this motor double checked and cleaned up before i start modding it. How much does ur average rebuild cost? Considering u replace rings and gaskets etc.
#5
RE: Riverside, CA 5.0 Rebuild Help
ORIGINAL: MidNite27
Cant hurt to get some buisness names if its not too much trouble from ya. I just wanna get this motor double checked and cleaned up before i start modding it. How much does ur average rebuild cost? Considering u replace rings and gaskets etc.
Cant hurt to get some buisness names if its not too much trouble from ya. I just wanna get this motor double checked and cleaned up before i start modding it. How much does ur average rebuild cost? Considering u replace rings and gaskets etc.
#6
RE: Riverside, CA 5.0 Rebuild Help
I think the BEST shop in the So Cal area is Superior Automitive a little bit more expensive than your average shop, its worth every cent. My dad had is engine built and a set of heads done at Speed-o-motive they an awesome job. Those are the only two i feel really comfortable to reffer because I have personally seen the work they do and it's top notch. If you go to Superior the owner is real cool and will give you a tour of the shop. The place is insane!
#10
RE: Riverside, CA 5.0 Rebuild Help
Superior has an awesome facility. The only negative comment I have about Superior is that they didn't seem to be much of a fuel injection place. I had my car dyno tuned there and it was done by a guy that didn't work for them. They basically rented dyno time to him, and I wasn't that impressed with his tune. They had some great cars there and they came highly recommended.
Hey luckythirteen13, can you PM me with your friend's info? I am in Anaheim and am looking for someone that can notch the pistons on my '86. I want to do heads and a cam but don't want to try notching the pistons myself. thx
Hey luckythirteen13, can you PM me with your friend's info? I am in Anaheim and am looking for someone that can notch the pistons on my '86. I want to do heads and a cam but don't want to try notching the pistons myself. thx
Thread
Thread Starter
Forum
Replies
Last Post
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM