dimebag

well i tryed leavin at 3k(not dumping it, but gettin on it quick) and suprisingly to me, i spun em...

mcfomco

I still have the stock axle's in my car and leave about 3,500 and on the spray with no problems as of yet.(Knocking on wood now)

mcfomco

You wanna spin just a little bit. You dont wanna dead hook or you will bog it.

dimebag

see i was spinnin them if i left hard, like 2500, 3000... which makes me think, looking back, i didnt heat them up enough...

sucks i cant spin em in 2nd(clutch will slip, atleast on the street), only 1st... maybe ill try to start in 1st, and jump into 2nd,,, but thatll be some effort, lol.

dimebag

yea i figure i wanna spin a little bit... but id like spin a good bit, then hook... i rly think it spun too much

mcfomco

Just make sure to get them good and wet and pull out of the water and side step the bitch in 2nd and let it eat.

dimebag

what tires do you run?

mcfomco

While in the water pop the clutch and let them turn over a time or two to get the wet is what I am trying to say then get out of the water. I will link you a video from last weekend of a pass I made. Pay no attention as the right rear tire quits spinning while the left is still wearing it out over there. http://vids.myspace.com/index.cfm?fu...oid=2010714213

mcfomco

26x10.5x16 et streets (bias ply)

mcfomco

In that vid I spun to much because the right rear didnt get hot enough to bite and the trac loc is going out. All the power is going to the left side which cant put it down by it lonesome.