Line Loc help
#1
Line Loc help
I'm new to this site and wanted to give it a shot. I have a 1990 5.0 mustang lx .. I just purchased a B and M line loc, i was just curious if neone has done one and could give me some pointers or a write up of what to do .. it would be greatly appreciated
#2
RE: Line Loc help
I've install a line lock a couple of times but on older cars.
Place it in series on the front brake line.
If the front line goes to a proportioning valve which is also a splitter some plumbing is neccessary.
Disconnect the front left and front right after the prop/splitter valve.
Plug one side out of the valve, run the other to the line lock IN.
Line Lock should have 2 OUT. They go to the front left and right.
Many other ways to plumb it in but this is preferred.
Place it in series on the front brake line.
If the front line goes to a proportioning valve which is also a splitter some plumbing is neccessary.
Disconnect the front left and front right after the prop/splitter valve.
Plug one side out of the valve, run the other to the line lock IN.
Line Lock should have 2 OUT. They go to the front left and right.
Many other ways to plumb it in but this is preferred.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM