91MustangGt

How do you install motor mounts on a 91 mustang gt? what do you need to do and stuff?

BAM614

look at it, its the easiest thing ever to do on these cars. 3 bolts per mount, jack it up a couple inches and replace, had mine done in NO time, my first time.

91lxstang

you need a long as breaker bar to get the big bolt out from under the car if you dont have air tools

88stang5.0GT

sorry to butt in but i have a question about this too i have energy suspension mounts and i went to ace and got bolts that thread in but when i try to tighten them they just pop... do i need special bolts for it?

dillon1340

mine was definitely not a easy job. equal lenght headers actually touch the motor mounts on passenger side. made it a pain in the ***. is it true that poly motor mounts will raise the motor a little bit?

kaik1969

Which ones does everyone suggest?I need to do the same on mine.

SoDakStang

I acutally put motor mounts for a convertible in mine. Lowered the engine. I have bbk shorty equals on and i don't any clearance issues involving the headers. My intake was way to tall for the hood I had so I lowered the engine and got a different hood, obviously. I don't really see a reason to raise the engine up. It will just create clearance problems with the hood. I know people with the same mounts and long tubes and have no problems...

Maxwelhse

I have prothane mounts on my car and I love them. As far as driving manners go you can't even tell they aren't stock. Getting them in was a pain though... The dude that said his motor mounts where simple had some beginners luck. I've done 3 sets of mounts in different cars now and they're ALWAYS a pain.

I have shorty headers and had them off when I did mine. I would recommend pulling your headers to do the job. Your life will be much simpler. And... I didn't notice any change in engine height after the prothanes... The driver's side might be a little higher since the stocker was collapsed.

dillon1340

yeah i didnt want to purposeley raise the engine i just wouldnt buy them if they did. when i bought my car i didnt realize how bad my motor mounts were until i changed them. when i was done i had to move the fan shroud up to it's original position, the guy before me had drilled new holes so it would line up instead of replacing the mounts.