94GT 5 Speed in a Fox
#1
94GT 5 Speed in a Fox
I know the tailshaft is longer than a fox T5 (7.18in)but if the 94 (7.85)driveshaft was used do you guys think I would be able to use it? Or are the driveshafts the same length on both Fox's and SN's?
#2
RE: 94GT 5 Speed in a Fox
fox and SN use the same driveshaft. The tailshaft is NOT longer... the INPUT shaft is longer. You can use a SN trans if you use the SN bell housing... but you might need to modify your crossmember to fit propery.
or you could justswap the input shaft from a fox tranny, into your SN tranny, and use a fox bellhousing.
either way will work
or you could justswap the input shaft from a fox tranny, into your SN tranny, and use a fox bellhousing.
either way will work
#5
RE: 94GT 5 Speed in a Fox
Which is the reason for the longer input shaft.But other than that they are the same? Release fork's are the same? Throw out bearings? Clutch cable length (adjustable cable should work if not, right)?
#7
RE: 94GT 5 Speed in a Fox
the clutch fork is different between a sn95 car and a fox...not sure if you could use either or ..but they are shaped a little different n ones longer...if i remember right the sn clutchfork is longer
Thread
Thread Starter
Forum
Replies
Last Post
BeatnikFink
New Member Area
6
10-01-2015 08:00 PM