shadykrug

I have a 91 LX with a TrickFlow Street Heat Intake Manifold. I need to change my valve cover gaskets and having a heck of a time trying to get the back bolt removed on the upper intake. There is barely any clearance and was wondering if there is a special tool to remove it? I purchased a small 12 point wrenchwith anend that moves up and down. I thought this might do the job, but the walls are to thick to get over the bolt. Any suggestions?

aode08

I use these and a long extension.You can buy them seperately, autozone, long or short. I prefer 6 point, inless you have a 12 point stamped bolt.

OneFine89Mustang

i had that same problem..the only solution i thought of was to take a 12 point wrench and melt it down to a much smaller size

mjr46

universals in 1/4 inch size