sofob0909

I Cant get them out. Tried hammering, drilling, new bit. It broke and scratched the paint. WHAT IS WRONG.
[align=left] [/align]

mjr46

I use a die gringer to grind head off and tap them through with a small punch

imnotmy77stang

stainless steel probably? a stronger drill bit (cobalt) should do the trick, or a die grinder like mjr mentioned

fourfivefour

Reverse the DAMN drill! Your going backwards! J/K
Drive the rivet arbor out with a punch then try drilling them out.

mjr46

so are they out yet??

sofob0909

got them. I bought a whole set of tungstin bits and broke the one, the rivits dulled three others. I checked it wasnt backwards.
What the f*** are they made of?
[align=left] [/align]

stang8689

stainless ones are a pain, you did knock the center out first right?

sofob0909

i used the drill and just went out it. I tried to stay patient. Then when i felt it was far enough i took a marker and punched the center through.

Tommorrow i ge tto do the door pins. Any suggestions?
[align=left] [/align]