4.10/4.30/4.56 Acceleration
#21
With a stock motor, yes I had exhast, and had to use my underdrive pully, but other than that STOCK junk yard stock still with dirt from the forklift. My car is light and leaves very well 1.7s on radials. Yes 12.50 with a stock motor.
Right now I have a 342. it made 408 on the back tires. I ran 10.79 @ 125 on slicks, and 11.34 @ 126.5 on radials, with a tremac 3550.
The pass with slicks 2nd was shifted at 5500 because any higher rpms than that it would not go into gear. I fixed it by removing every other tooth off of the 2nd gear, blocker ring and sycronizer. I went back on radials to make sure that 2nd was fixed, 11.34 @ 126.5. Now I need to go back with the slicks cause I think it will go better than 10.5s
My CAR works, when it is like this the motor don't have to make 10,000 hp
Right now I have a 342. it made 408 on the back tires. I ran 10.79 @ 125 on slicks, and 11.34 @ 126.5 on radials, with a tremac 3550.
The pass with slicks 2nd was shifted at 5500 because any higher rpms than that it would not go into gear. I fixed it by removing every other tooth off of the 2nd gear, blocker ring and sycronizer. I went back on radials to make sure that 2nd was fixed, 11.34 @ 126.5. Now I need to go back with the slicks cause I think it will go better than 10.5s
My CAR works, when it is like this the motor don't have to make 10,000 hp
Thread
Thread Starter
Forum
Replies
Last Post
AmericanMuscle4.6GT
2005-2014 Mustangs
7
11-10-2015 02:06 PM
Offendant
V6 (1994-2004) Mustangs
6
09-23-2015 07:21 PM
tj@steeda
Steeda Autosports
0
09-08-2015 11:50 AM
zanemoseley
2005-2014 Mustangs
6
09-06-2015 12:58 PM