correct gasket/seal kit for 95 with mods
#1
correct gasket/seal kit for 95 with mods
95 gt
have gt40 lower, cobra upper.
gt40 iron heads
65mm tb
also, i have roller rockers that im pretty sure are not the stock ratio. when they were installed, they wouldnt clear the valve covers (they touched). installer used a thicker gasket (or perhaps doubled a regular gasket, not sure)
kit from summit:
http://store.summitracing.com/partde...5&autoview=sku
now, suppose this is in general the correct kit, is there anything i need to look out for?
for those of you familiar with summit, are they knowledgable to advise on like specific valve cover gaskets, or head gaskets etc that would be better considering any mods? im guessing they would be, but who knows.
thanks in advance
have gt40 lower, cobra upper.
gt40 iron heads
65mm tb
also, i have roller rockers that im pretty sure are not the stock ratio. when they were installed, they wouldnt clear the valve covers (they touched). installer used a thicker gasket (or perhaps doubled a regular gasket, not sure)
kit from summit:
http://store.summitracing.com/partde...5&autoview=sku
now, suppose this is in general the correct kit, is there anything i need to look out for?
for those of you familiar with summit, are they knowledgable to advise on like specific valve cover gaskets, or head gaskets etc that would be better considering any mods? im guessing they would be, but who knows.
thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM