manual rack question
#1
manual rack question
im changing my power steering rack to manual and im having a hard time getting the tie rod end out of the spindle my question is are there any tricks or easy ways to get it out or do i just have to beat it out any help would be appreciated thanks
#4
well i tired the pickle fork but it is tearing up my ball joint and i beat it so much im starting to flatin the top of the bolt to where when it does break loose if i beat it anymore its not going to go through the hole on the spindle but i guess im going to go out tommorow and beat the **** out of it lol
#5
Go out there 2-3 times a day and guive it a good soaking with penetrating oil like PB Blaster. Hint: WD-40 is NOT a penetrating oil.
Heating the arm will make the hole bigger.
You may have noticed that when you smack the stud with a hammer, it feels a little "soft". That's because the arm will flex a little when you hit it. Use a bottle jack under the arm, right nect to the tie rod end. That smack it.
The part is already mangled and useless. Go down to Autozone and borrow a pickle fork. That and a 3# sledge will almost always break it free.
Heating the arm will make the hole bigger.
You may have noticed that when you smack the stud with a hammer, it feels a little "soft". That's because the arm will flex a little when you hit it. Use a bottle jack under the arm, right nect to the tie rod end. That smack it.
The part is already mangled and useless. Go down to Autozone and borrow a pickle fork. That and a 3# sledge will almost always break it free.