audman25

Hey guys changing motor out had a melted piston edelbrock performer heads on cylinder6 has pitting pretty deep you think its still good

mjr46

post pics

audman25

I believe detonation caused this issue y'all guys still think their ok

tinman

I can't tell from the pic but is the chamber got pits in it too?
If not I'd say to find a head shop that welds aluminum and have them weld it up.
Those type places are sort of common anymore but you may have to ask around to find out where they are.
I think I'd start at the local machine shop.

audman25

The chambers are fine just upper area outside of chamber

mjr46

as long as it doesn't enter into the firing ring sealing area, you're fine, I've seen way worse and not an issue on those

tinman

LOL, I've run much worse looking heads myself..........

audman25

Thanks guys for the info and help will slap them on and use